Our apologies.

This rig has been sold.

Wilson 75 +/- 11,000' Drilling Rig

Draw Works
1000 HP with two 3408 Caterpillar engines with twin disc torques, single drum drawworks. 1 1/8” grooving. Mounted on drive in seven axle carrier
with 18 x 22.5 tires with drill spool and 3,500 feet 1 1/8” drill line.

Derrick and Sub structure
Wilson 131’ and 345,000 SHL derrick. New sub 17’ scooping with 30” high ramp on 12” high wooden matting boards, with steps, hand rails,
V door. Sub will scope to 22’ high if needed.

Mud Pumps
2 Gardner Denver PZ-9 1,000 HP triplex mud pumps with D-398 Caterpillar engines, National 300-64 torque converters, with chain cases,
pulsation dampeners, high pressure piping, 3” pop off valve, with 5” x 6” charging pump, 50 gallon diesel day tank, 50 gallon air volume
tank all rigged up on 30’ 3 runner master skid.

Mud Tanks
935 BBL total with 825 BBL active working system. Suction tank, 1 new 10’ x 35’ x 8’ V-crimped tanks with 10’ porch on end, three 10’ runner skids.
Shaker tank, 10’ x 37’ x 8’ porch on end. Four 5” x 6” centrifugal pumps with 50 HP electric motors manifold together for mud mixing, 1 mud hopper,
six 10 HP mud mixers, 2 Swaco linear motion shakers with shaker slide, one 2 cone desander, one 12 cone desilter, with 16” mud trough from
shakers to premix compartment, with 6” low pressure mud roll lines, 10” butterfly valves for dumps. Suction tank wall with three 10” butterfly
valves for tank leveling of fluid with all internal piping for both mud pumps to suck fluid of all 3 suction compartments, top of tank is covered with
grating, new lights and wiring with 2 sets of steps and hand rails.

Generator House
1 new 10’ x 50 ’x 8’ V crimped generator house with 2 Caterpillar 3412-545 KW generators sets with new MCC wiring plug panel, with all new
wiring and lights. 2 new 25 HP screw air compressors. Two 50 gallon day tanks for generator sets.

Rotary Table
Ideco, 27 ½”

Traveling Block
New, 200 ton shorty block with 1 1/8” grooving.

Swivel
200 ton, new

Top Dog House
1 new 8’ x 24’ x 8’ V crimped Top Doghouse with air conditioning unit. Drillers knowledge box, 2 new 3” steel factory doors and windows, shelves
and bench in house, with new lights and wiring. Top dog house will swing up out of water tank.

Fuel Tank
9,000 gallon, with dual fuel pumps and filters, with oil lubster on end.

Water Tank
1 new 10’ W x 40’ L, V crimped tank with 10’ porch with two 2” x 3” centrifugal pumps with 20 HP electric motors.

Accumulator
5 station, 80 gallon accumulator mounted on end, with accumulator lines mounted on side of 8’ x 26’ x 3’ Junk basket.

Choke Manifold
4 valve, twin choke, 3,000 PSI

BOP Stack
13 5/8’ x 5,000PSI Shaffer annular, and 13 5/8’ x 5,000PSI Shaffer SL double, 3’ x 5,000PSI valves with cross and 2 manual chokes with 8” buffer tank.

Drill Pipe
9,500 feet 4 ½” G 105 XO

Drill Collars
20, 6 ½” slick drill collars

Pipe Handling Tools
250 ton 4 ½” drill pipe elevator, 4 ½” drill pipe slip, 8” drill collar slip, 6” drill collar slip, 8” drill collar safety clamp,5 ¼” hex Kelly with Kelly drive
bushings, tongs with 4 ½” heads to 8 5/8”, set of 96” elevator links, Kelly spinner, pipe spinner.

Instrumentation
Satellite auto driller, Martin Decker weight indictor

Drill Line
5,000 ft. 1 1/8” drill line.

Pipe Racks & Cat Walk
18” 2 section catwalk & 4 sets of pipe racks.

Tool Pusher’s Office & Quarters
14’ x 45’ x 8’, with office, living quarters.

Crew Quarters
14’ x 55’ x 8’ 12 man quarters with lounge and kitchen

Change House Toilet
12’x 8 x 8’ with shower, toilet, wash basin, bench and A/C & hot water heater.

Change House
8’ x 40’ x 8’ V crimped house with lockers in one end and bench. Parts end has shelves and tools bench with lights and wiring. 3’ steel factory
door installed in each end and 3’ door in center of house.

Fork Lift
Caterpillar 8,000 extend reach 4 wheel drive